2391168504 – 8C3F(150HP,575,6,W)
Franklin’s 8-inch submersible motors are typically used in large demanding water wells requiring high flow rates or deeper installations. These motors are tough, built to last, and come in a variety of construction options.
| Item: | 2391168504 |
| Model: | 8C3F(150HP,575,6,W) |
| Type | Sand Fighter |
Ratings |
|
| HP 60Hz | 150 hp |
| Frequency | 60 Hz |
| Phases | Three-Phase |
| Amps - Full Load | 164 A |
| Amps - Service Factor | 182 A |
| Volts | 575 VAC |
| Voltage Tolerance (%) | -10.0% / +10.0% |
| Wire | 3-Wire |
| Motor Connection | DOL |
| Thrust Bearing Rating | 10000 lb |
| Lead Length | 13 ft |
| Motor | Encapsulated |
| Continuous Duty | Yes |
| Efficiency Service Factor Load [%] | 88.00 % |
| Protection [IP] | IP68 |
| Lead Wire Size | AWG #2 |
| Motor Insulation Classification | F |
| Poles | 2 |
| S.F. | 1.15 |
Operation |
|
| Motor Cooling | Water |
| Minimum Cooling Flow | .50 ft/sec |
| Motor Ambient Temperature Rating Nominal | 86 °F |
| Thrust Bearing Rating | 10000 lb |
| Motor Adapter | Double flange |
| Rotation | Counter clockwise facing the shaft |
| SubTrol Heat Sensor | Yes |
| Winding Resistance (Main Winding) | .06-.08 |
Materials of Construction |
|
| Motor Shaft End - Material | 17-4SS |
| Thrust Bearing | Kingsbury Type |
| Seal | Mechanical Seal |
| Lead Insulation Material | XLPE |
| Diaphragm Material | Nitrile Rubber (NBR) |
| Motor Bottom End Bell Material | Cast Iron with E-Coat Paint |
| Motor Fill Solution (Water Soluble / Non Toxic) | Yes |
| Motor Fill Solution | FES91 |
| Motor Top End Bell Material | Cast Iron with E-Coat Paint |
| Shaft Slinger Material | Nitrile Rubber (NBR) |
| Stator Ends Material | Carbon Steel |
| Stator Fill | Resin |
| Stator/ Motor Shell Material | 300 Series SS |
| Winding Material | Copper |
Dimensions |
|
| Motor Diameter - Physical Diameter | 7.70" |
| Motor Length | 77.8 " |
| Product Weight | 735 lb |
| Product Weight with Pack | 840 lb |
| Carton Length | 96 " |
| Carton Width | 9 " |
| Carton Height | 17 " |
| Shaft Diameter | 1.5 " |
| Shaft End | Spline |
Other |
|
| Drinking Water Agency Approvals | ANSI/NSF Standard 61 |
| Electrical Agency Approvals | UL |
| Warranty Standard Time | 12 Month Install / 24 Month Manufacturing |
| Repair Kit Available | Yes |
