2791059004 – 8H3F(125HP,460/380,6/5)
Franklin’s 8-inch submersible motors are typically used in large demanding water wells requiring high flow rates or deeper installations. These motors are tough, built to last, and come in a variety of construction options.
| Item: | 2791059004 |
| Model: | 8H3F(125HP,460/380,6/5) |
| Type | Sand Fighter |
Ratings |
||
| HP | 125 hp | |
| Frequency | 50/60 Hz | |
| Phases | Three-Phase | |
| Amps - Full Load | 161 A | |
| Amps - Service Factor | 184 A | |
| Volts | 380 VAC / 460 VAC | |
| Voltage Tolerance (%) | -10.0% / +10.0% | |
| Wire | 3-Wire | |
| Motor Connection | DOL | |
| Thrust Bearing Rating | 10000 lb | |
| Lead Length | 13 ft | |
| Motor | Encapsulated | |
| Continuous Duty | Yes | |
| Efficiency Service Factor Load [%] | 86.00 % | |
| Protection [IP] | IP68 | |
| Lead Wire Size | AWG #2 | |
| Motor Insulation Classification | F | |
| Poles | 2 | |
| S.F. | 1.15 | |
| Motor Cooling | Water | |
| Minimum Cooling Flow | .50 ft/sec | |
| Motor Ambient Temperature Rating Nominal | 167 °F | |
| Thrust Bearing Rating | 10000 lb | |
| Motor Adapter | Double flange | |
| Rotation | Counter clockwise facing the shaft | |
| SubTrol Heat Sensor | NO | No |
Materials of Construction |
|
| Motor Shaft End - Material | 17-4SS |
| Thrust Bearing | Kingsbury |
| Seal | Mechanical Seal SiC/SiC |
| Lead Insulation Material | XLPE |
| Diaphragm Material | FKM |
| Motor Bottom End Bell Material | Cast Iron with E-Coat Paint |
| Motor Fill Solution (Water Soluble / Non Toxic) | YES |
| Motor Fill Solution | FES92 |
| Motor Top End Bell Material | Cast Iron with E-Coat Paint |
| Shaft Slinger Material | Nitrile Rubber (NBR) |
| Stator Ends Material | Carbon Steel |
| Stator Fill | Resin |
| Stator/ Motor Shell Material | 300 Series SS |
| Winding Material | Copper |
Dimensions |
|
| Motor Diameter - Physical Diameter | 7.70" |
| Motor Length | 68.8 " |
| Product Weight | 641 lb |
| Product Weight with Pack | 700 lb |
| Carton Length | 78.5 " |
| Carton Width | 9 " |
| Carton Height | 17 " |
| Shaft Diameter | 1.5 " |
| Shaft End | Spline |
Other |
|
| Warranty Standard Time | 12 Mo. from Date of Install / 24 Mo. from Date of Manufacturing |
