2363108120 – 6C3F(5HP,460/230,6,W)SF
Franklin's 6-inch submersible motors are typically used in large demanding water wells requiring high flow rates or deeper installations. These motors are tough, built to last, and come in a variety of construction options. These motors provide large amounts of water for irrigation, community water systems, and factories where large flows or pressures are required. We understand how important it is to produce reliable systems to avoid significant costs due to failure or downtime.
Item: | 2363108120 |
Model: | 6C3F(5HP,460/230,6,W)SF |
Type | Sand Fighter |
Ratings |
||
HP | 5 hp | |
Frequency | 60 Hz | |
Phases | Three-Phase | |
Amps - Full Load | 7.5 A | |
Amps - Service Factor | 20 A | |
Volts | 230 VAC / 460 VAC | |
Wire | 3-Wire | |
Motor Connection | DOL | |
Thrust Bearing Rating | 3500 lb | |
Lead Length | 13 ft | |
Motor | Encapsulated | |
Continuous Duty | Yes | |
Efficiency [η] - Full Load (%) | 79.00 | |
Efficiency Service Factor Load [%] | 79.00 % | |
Protection [IP] | IP68 | |
Lead Wire Size | AWG #8 | |
Lead Retainer Method | Lead Jam Nut | |
Motor Efficiency | 79.0 | |
Motor Insulation Classification | F | |
Poles | 2 | |
S.F. | 1.15 | |
Motor Cooling | Water | |
Minimum Cooling Flow | .50 ft/sec | |
Motor Ambient Temperature Rating Nominal | 86 °F | |
Thrust Bearing Rating | 3500 lb | |
Motor Adapter | Double flange | |
Rotation | Counter clockwise facing the shaft | |
SubTrol Heat Sensor | NO | No |
Temperature Rating | 86 °F |
Materials of Construction |
|
Motor Shaft End - Material | 304SS |
Thrust Bearing | Kingsbury |
Seal | Mechanical Seal |
Lead Insulation Material | Overmolded |
Diaphragm Material | Nitrile Rubber (NBR) |
Motor Bottom End Bell Material | Cast Iron with E-Coat Paint |
Motor Fill Solution (Water Soluble / Non Toxic) | YES |
Motor Fill Solution | FES91 |
Motor Top End Bell Material | Cast Iron with E-Coat Paint |
Shaft Slinger Material | Nitrile |
Stator Ends Material | Carbon Steel |
Stator Fill | Resin |
Stator/ Motor Shell Material | 300 Series SS |
Winding Material | Copper |
Dimensions |
|
Motor Diameter - Physical Diameter | 5.44" |
Motor Length | 25.8 " |
Product Weight | 101 lb |
Product Weight with Pack | 103 lb |
Carton Length | 34.5 " |
Carton Width | 7.25 " |
Carton Height | 10.5 " |
Shaft Diameter | 1 " |
Shaft End | Spline |
Other |
|
Drinking Water Agency Approvals | ANSI/NSF Standard 61 |
Electrical Agency Approvals | CE / CSA / UL |
Warranty Standard Time | 12 Months |